C303, Tgb13

Power Steering 2

Leave a comment

While I wait to give the shaft to my mate for turning my attention goes back to the rest of the box.

Seals and teflon rings swapped.  Then put back together.  65 Nm and blue threadlock

Quick bit of plastic over the main shaft hole and a good spray of paint.  Thanks to the washing line

Seal kit. No main seal. Part 149 in previous pic
Seal kit. No main seal. Part 149 in previous pic
3 seals and a teflon ring off
3 seals and a teflon ring off
replaced rings. don't forget the little one, top right in the pic
replaced rings. don’t forget the little one, top right in the pic
plug rig changed and put back
plug ring changed and put back
ensure dongle on cylinder lines up with groove in casing and insert. Tighten to 65nm. add threadlock
ensure dongle on cylinder lines up with groove in casing and insert. Tighten to 65nm. add threadlock
coat of paint. like new
coat of paint. like new

  (2328)

Likes(1)Dislikes(0)

Leave a Reply